How do your pair the ACWRMC remote with the AC range of heaters?

Pairing the ACWRMC to the AC Heater

Pair button

Process

1. Power off the heater at the isolation switch.
2. Ensure the heater mode selection rocker switch is set to Continuous or schedule mode
3. Power on the heater at the isolation switch
4. The heater will then broadcast, looking for a connection for 2 minutes. 
5. Press and hold the PAIR button on the remote longer than 5 seconds. The remote will scan for an appliance, 
6. once detected the appliance will emit a series of audible beeps. If it is the correct appliance, press and hold the PAIR button longer than 5 seconds to verify, 
7. the appliance LED will flash red and green whilst emitting a series of beeps. 
8. When complete the appliance will beep to confirm bonding, and the beeping will discontinue. The appliance is then considered bonded with the remote. 

If there are more than one appliance within range and the initial appliance being communicated with is not the intended device then connection can be rejected by a quick press of the PAIR button The remote will rescan and initiate pairing with the next available device. Repeat the process until the correct appliance has been paired

Applicable models

AC3W, AC45W, AC6W