My LWPM410 Modbus network card on a heat pump is not responding correctly when issued commands from a BMS

This is set on the screen of the heat pump. Hold Menu +Enter together, scroll down to “Network” and press enter.

If that is not the issue, please physically check the cable connection between the BMS and the LWPM410 Modbus card. There are three wires, +, - & Ground. On each Modbus device on the network they must be connected correctly and no short circuits between the wires on the terminal blocks.

Require additional help? Please follow link below

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article